Page17of18
IMC01 Maintenance Manual
Version 1.03
4) Go back the main screen, and the use your finger to touch the hopper sensor. The processing wheels and
rollers in the IMC01 will run for a while.
Figure 4-18 Touch the Hopper Sensor
4.4. Sensors Replacement
4.4.1. Hopper Sensor
Please contact and return to us for repairment.
4.4.2. Stacker Sensor
Please contact and return to us for repairment.
4.4.3. Counting Sensor
Please contact and return to us for repairment.
4.5. Power Board Replacement
Please contact and return to us for repairment.
4.6. Mainboard Replacement
Please contact and return to us for repairment.
To Next Page
Loading...
