Page5of18
IMC01 Maintenance Manual
Version 1.03
2.0. Cleaning the Machine
Any dust, dirt or other substances sticking to the sensor will interfere with the normal operation of the sensor
and cause erroneous counting results. Therefore, the sensor and roller shaft shall be cleaned with the attached
cleaning tools as necessary every day.
Please turn off the power switch before cleaning to prevent electric shock or other injury accidents.
Please do not use chemicals such as benzene, thinner or water.
2.1. Clean the Hopper
There are 3 parts need to be clean in the hopper: hopper sensor, banknote processing wheel and the banknote
entrance.
1) Hopper Sensor.
Figure 2-1 Hopper Sensor
As shown at the above figure, clean the hopper sensor with nylon brush or cleaning cloth.
2) Banknote processing wheel
As shown in the following figure, clean the banknote processing wheel with nylon brush or cleaning cloth.
Figure 2-2 Banknote Processing Wheel
3) Banknote entrance
As shown in the following figure, clean the banknote entrance with nylon brush.
To Next Page
Loading...
