Muncie ADVANTAGE + - Hardware Related Messages; Panel Faults

25
Hardware Related Messages:
No Master Module Found – Master Module not detected upon startup. Check wiring and correct.
Master Lost – Master Module disconnected after startup. Check wiring and correct.
Slave Lost – Slave Module disconnected after startup. Check wiring and correct.
Motor Mod Lost – Motor Module disconnected after startup. Check wiring and correct.
Panel Lost – Cylinder Panel disconnected after startup. Check wiring and correct.
Liquid Feedback Sensor Failure –ow turbine not detected. Check wiring and correct. If not utilizing ow turbine,
switch to open loop setting in calibration menu.
Lost auger feedback – feedback sensor not detected. Check wiring and correct. If not utilizing feedback sensor,
switch to open loop setting in calibration menu.
Panel Faults:
Found Configuration Display Corruption – Conguration le corrupted. Please contact Muncie and check wiring
on controller so that it is connected to ignition triggered shutdown.
Processor was reset forcibly – This error indicates an unexpected system crash. If problem persists, please
contact Muncie.
Panel Comm Fault – This message indicates a processor communication error. Try resetting the controller. If
problem persists, contact Muncie.
ELECTRICAL GUIDE
CONTROLLER ERRORS