© Munters AB, 2018 17
4.7 New Flock
The New Flock screen causes the RFS-6 to erase history data and restarts the growth cycle over from the
beginning.
4.8 Alarm Reset
You can disable the alarm relay for current alarms. This conveniently silences the alarm bell while you
work on the alarm issue. When a new alarm occurs, or the alarm reoccurs, the RFS-6 generates a new
alarm.
4.9 Alarm Time
The RFS-6 enables individual enabling times for the various alarms. The alarms do not register other than
in the defined times. You can disable all alarms during sleeping hours. Table 3 lists the alarm codes.
• Defining the from/to time as 00:00 to 00:00 disables the alarm.
• Codes 1 – 8 are alarms. When these alarms take place, the screen displays the alarm as a
blinking message. Codes 9 – 11 are informational messages that appear in the History >
Alarms table. These codes only inform you of an event that happened, not of an ongoing event.
• Codes 9, 10, and 11 are not time limited.
Table 3: RFS-6 Codes and Alarm Times
1 Scale 1 Failure (Feed Scale)
2 Scale 2 Failure (Bird Scale)
3 Weigh Tank Overflow
4 Auger 1 Time Overrun
To Next Page
Loading...
Need help?
General
