MW BETA Series - Operating the Device; Auto-Restart Function; Emergency Function Operation

9 / 21
BETA series
Model:
BETA 12K WIFI
BETA-user manual-EN-
R1 27.07.2020
Obrázek n ejde
zobrazit.
Obrázek n ejde
zobrazit.
6. O PERATING THE DEVICE
6.1. AUTO-RESTART FUNCTION
The appliance is present auto-restart function by manufacturer. In case of a sudden power failure, the module memorizes the
setting conditions bedore the power failure. When the power restores, the unit restarts automatically with all previous settings
preserved by the memory function.
• To deactivate the AUTO-RESTART function, proceed as follows.
1. Switch the air conditioner off and plug it off.
2. Press the emergency button meanwhile plug it in.
3. Keep pressing the emergency button for more than 10 seconds until you head four short beeps from the unit. The
AUTO-RESTART function is deactivate.
• To activate the AUTO-RESTART function, follow the same procedure until you hear three short beeps from the unit.
6.2. E MERGENCY FUNCTION
If the remote controller fails to work or maintenance
necessary, proceed as follows. Open and lift the front panel up
to an angle to reach the emergency button.
1. One press of the emergency button (one beep) will
lead to the forced cooling operation.
2. Two press of the emergency button within 3 sec (two
beeps) will lead to the forced heating operation.
3. To switch off the unit, you just need to press the
button again (a single long beep).
4. After 30 minutes in forced operation, the air
conditioner will automatically start working in 23°C
cooling mode, aut fan speed.
• The shape and position of the emergencybutton may be different according to the model, but their function is the
same.
• The external static pressure of heat pumps is 0 Pa for all models.