MyBinding Standard APC45 Programmable - Page 33

25
Creating a Cutting Program (Input) Operation Procedures
3-6 Creating a Cutting Program (Input)
Input the cutting length for the last
step.
- Press the key while the value is “0” in
step 14.
Save the program.
- Press the key on the confirmation
screen below and finish creating the program.
- The program cutting mode starts and the LED
on the button is illuminated.
En
t
14 / 0
14:013:90.0
COURSE14
After the value for the last
step 13 is input,
Press the key while the
value is “0” to complete the
program.
En
t
The value for
the step 14 is
ready to be
input.
En
t
1/13
2:280.01:320.0
COURSE14
MEMORIZE?
Y
:
"Ent" N
:
"C"
EXIT?
Y
:
"Ent" N
:
"C"
When the key is pressed
while the input value is 0,
En
t
The exit confirmation
screen appears.
The program of the course
number 14 starts.
When the key is pressed,
En
t
The memory
confirmation screen
appears.
When the key is pressed,
En
t