52.
6. Feed the spinnaker halyard from inside to outside
through the top block.
7. Attach the Dyneema line end of the spinnaker halyard
temporarily to the bottom of the mast.
8.3. Spinnaker halyard
1. Take the spin bale line and a carbo 29 mm T2 block.
2. Feed one end of the spin bale line through the pre-drilled
holes in the mast and tie a figure 8 knot.
3. Feed the other end of the spin bale line through the
middle of the 29mm block and feed it through the pre-
drilled holes and fixate it tightly with a figure 8 knot.
4. Install the block line to the top of the block and the strap
eye above. Fixate the block at the same height as the bale
line is positioned.
Tape the ends of the bale line to slide easily through
the pre-drilled holes!
3mm 4mm 5mm
Bale line Bale up line Spinnaker halyard
1x
5. Feed the spinnaker halyard through the starboard
spreaders.
To Next Page
