34
1. Knot both ends of the cunninghamline to the
mouseline pre-installed in the front crossbar.
2. On port side, un-knot (from the small clamcleat)
the front pre-installed mouseline in the front
crossbar (from the small clamcleat) and attach
it with the port side cunningham line with two
bowlines.
3. On starboard side, un-knot (from the small
clamcleat) the mouseline and pull the line
through the internal system until it comes out of
the front crossbar.
4. Attach both ends to each other as shown in A
with two bowlines.
5. Adjust the connection to locate it inside the front
crossbar.
6. When lowering the mast, you need to re-install
the mouseline.
4.7 Cunningham continuous system
A
To Next Page
Loading...
