3. Un-knot the spinnaker halyard (temporarily
x on the bridle) and feed it through the two
bottom patches and xate it to the loop of the
3rd patch with a bowline.
4. Divide the spin sheet in two egual lengths and
loop the sheet through itself as shown in the
picture.
5.3 Raising the jib
1. Hook the S-hook on the jib, make sure the upper
hook is facing the mast.
2. When closing the zipper, make sure the halyard
is zipped in the lu of the sail. Hoist the jib in
small episodes in order to zip down.
3. Hoist the jib until the S-hook is pulled through
the ring.
4. Gently pull the jib down to lock the S-hook in the
ring.
5. Install the jib downhaul line by feeding it
through the eyelet, wrapping it around the pole
and xating it to the base with a bowline.
6. Wrap the velcro tape around the front
turnbuckle.
7. Attach the jibsheet small to the clew of the sail.
41
To Next Page
Loading...
