8. Loop the laces using the trampoline tie buttons.
9. Tension the line slightly and secure it
temporarily.
10. Tie the side lace line on
starboard
side to the
most front loop closest to the front crossbar.
Make sure the trampoline is in the middle
of the catamaran.
11. Feed the line through the loops from top to
bottom.
12. Loop around the bolt and continue
underneath
the line.
13. Tension the line slightly.
4. Fixate the trampoline with the trampoline plate
on the buttons on the front crossbar. Make sure
you bring the two loose aps between the beam
and the dolphin striker.
5. The plate needs to be all the way against the
front crossbar. Make sure the buttons stick out
properly.
6. Wrap the trampoline around the front crossbar,
make sure the six cutouts t the self tacking jib
track bases.
7. Re-install the self tacking jib track.
8
14. Tie the lacing line temporarily with half-hitch
knot at the last loop.
15. The beginning of the port side is a reection of
the starboard side.
3. Loop the rear lacing line through the tie rod as
shown in the picture. Start at the port side of the
trampoline.
To Next Page
Loading...
