NAD 7020e - Audio Section Alignment; Initial Adjustment Procedure; Final Adjustment Procedure

ALIGNMENT METHOD
AUDIO SECTION 7220PE
IMPORTANT
Speaker Impedance switch should be in 8 ohm position while adjusting center volatge and idling current.
INITIAL ADJUSTMENT (No load connected)
A. CENTER VOLTAGE
1, Connect DC millivoltmeter to L channe) output terminals.
2. Turn on and adjust to 0 ¥ +- 30mV with VR411 (100 ohm). 7
Connect DC millivoltmeter to R channel output terminals and adjust VR412 to 0 V +- 30mv.
B. IDLING CURRENT
1. Remove solder short across R455 and R456.
2. Connect DC millvoltmeter across P403,P404 (output transistor's collector resistor) and adjust R443
for 26-30mY reading on meter.
Repeat adjust with R444, connecting meter across P405,P406.
3. Leave power on for minimum 5 minutes.
FINAL ADJUSTMENT
C. CENTER VOLTAGE
1. Repeat step A above.
D. IDLING CURRENT
1. Repeat step B and adjust with R443, Rd for 30mV reading on meter.
2. After the alignment is finished, 1 ohm resistor R455,R456 is shorted by solder short.
mo
CENTER VOLTAGE ADJ
RAa3
fOLING CURRENT Ao)
Mace
IDLING CURRENT ADJ
REZ
CENTER VOLTAGE AD}
AMPLIFIER ADJUSTMENT POINTS
-- 5 --