EasyManua.ls Logo

NAD 710 - TROUBLESHOOTING; NO SOUND OR SINGLE CHANNEL ISSUES; AUDIO QUALITY AND NOISE PROBLEMS; INTERFERENCE AND SIGNAL RECEPTION

NAD 710
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NA
D
7
GB
SET indicator lights up. Press or to select one of
the twelve FM, or twelve AM, Preset numbers. Each
time these buttons are pressed, the display panel will
flash for a few seconds showing the Preset number
and the Presets frequency.
CHANGING A PRESET.
You can store a new station into a used Preset by
simply going through the Preset storing process and
placing a new station over the existing one.
TROUBLESHOOTING.
NO SOUND.
Power AC power cord unplugged or power not switched on. Check AC power cord.
Tape Monitor selected. De-select Monitor mode.
Portable input selected. De-select Portable input.
Station not selected or weak signal. Re-tune.
Thermal cut out operated. Switch off and reduce volume setting. Switch on
after unit has cooled.
Internal fuse blown. Consult dealer.
NO SOUND ONE CHANNEL.
Volume Control balance not even. Adjust inner and outer sections of Volume Control.
Input lead disconnected or damaged. Check leads and connections.
WEAK BASS/ DIFFUSE STEREO IMAGE.
Speakers connected to the power amplifier wired out of phase. Check the “+” and “–” connections to both
speakers.
LOUD BUZZ OR HUM.
RCA connector not properly inserted or faulty lead. Push all connectors firmly home, check leads.
TWO SIGNALS HEARD SIMULTANEOUSLY.
Portable mode selected and unit connected to the Portable De-select Portable mode.
is playing in addition to another selected input.
NOISE ON TUNER.
Hiss. Weak signal. Check station tuning. Adjust or replace antenna.
Distortion. Multi-path signals or interference from another station. Check station tuning. Adjust or replace antenna.
Whistles or buzzes on FM & AM. Interference from other Check station tuning. Switch off or move the
electrical sources - computers, games consoles. source of the electrical noise.
Whistles or buzzes on AM: Interference from fluorescent Check station tuning. Adjust or replace AM
lighting or electrical motors. antenna.
NO STATION FOUND IN SEARCH MODE.
Inadequate aerial signal. Check aerial connections, adjust position of ribbon
antenna.

Related product manuals