To Next PageTo Next PageWhy is there no sound coming from my NAD C315BEE Amplifier?
If your NAD Amplifier isn't producing any sound, there might be a few reasons: * Check that the AC lead is properly plugged in and the power is switched on. * Ensure that the mute function is off. * If headphones are plugged in, unplug them.
What to do if POWER/PROTECTION LED turns red during operation of NAD C315BEE Amplifier?
If the POWER/PROTECTION LED on your NAD Amplifier turns red during operation, it indicates that the amplifier has overheated. Turn the amplifier off. Ensure that the ventilation slots on top and bottom are not blocked. After it has cooled down, turn it back on.
What to do if there is no sound in one channel of my NAD C315BEE Amplifier?
If you're experiencing sound only in one channel of your NAD Amplifier, here's what you can check: * Make sure the balance control is centered. * Check the speaker connections to ensure they are properly connected and not damaged. * Inspect the input leads and connections for any damage or disconnections.
What to do if the NAD C315BEE Amplifier remote control is not working?
If the remote control for your NAD Amplifier isn't working, try these steps: * Check the battery. Make sure it's not flat and is correctly inserted. * Ensure that there are no obstructions blocking the IR transmitter or receiver windows. * Make sure the IR receiver isn't in direct sunlight or very bright light. If it is, move the unit away from direct sunlight and/or reduce the ambient light.
Why does my NAD Amplifier have weak bass or a diffused stereo image?
If your NAD Amplifier is producing weak bass or a diffused stereo image, the speakers might be wired out of phase. Check the connections to all speakers in the system.
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Input Sensitivity | 200mV |
| Speaker Impedance | 4-8 ohms |
| Input Impedance | 47kΩ |
| Power Output | 40W (min continuous power into 8 Ohms) |
Guidelines for proper grounding of CATV systems and connection to building grounding.
Ensure adequate ventilation space around the unit for proper operation and to prevent overheating.
Specific instructions for UK customers regarding mains plug suitability and fuse replacement.
Overview of the C315BEE's front panel controls and their labels.
Identification of input and output connection terminals on the rear panel.
Illustration and explanation of different connector types for speaker terminals.
Detailed explanation of operating front panel controls like Standby, Inputs, Tone, and Volume.
Important safety advice during operation, including volume levels and headphone use.
Additional operational notes, including media player connections and cable handling.
Detailed operation of rear panel connections for various audio sources and speakers.
Instructions on how to properly connect speaker wires using bare wires or pin connectors.
Explanation of the NAD remote control handset functions and battery installation.
