LINE LEVEL OUTPUTS
FM BAND
Tuning Range 87.5MHz - 108.5MHz
(50kHz steps)
Usable Sensitivity (98 MHz) 12dBµ
Signal/Noise Ratio
(60dBµ IHF-WTD Mono) 65dB
(60dBµ IHF-WTD Stereo) 60dB
Frequency Response ±1.5dB (20Hz - 15kHz, 60dBµ)
Channel Separation
(60dBµ) 30Hz 30dB
1kHz 35dB
10kHz 30dB
Capture Ratio (40dBµ) 3dB
AM Suppression 50dB (60dBµ, 100% Mod. FM, 30% Mod. AM)
Image Rejection (119.4MHz) 70dB
I.F. Rejection (10.7MHz) 70dB
Pilot Suppression (60dBµ) 60dB
Total Harmonic Distortion Mono 0.5%
Stereo 0.8%
Auto Search 15 - 25dBµ
RDS Decode Sensitivity ≤30dBµ
AM SECTION
Tuning Range 530kHz - 1710kHz (10kHz steps, 120V version)
531kHz- 1602kHz (9kHz steps, 230V version)
Usable Sensitivity 50dBµ (999/1000 kHz)
S/N Ratio 45dB (5mV in)
Total Harmonic Distortion 3% (5mV in)
IF Rejection (450 kHz) 40dB
Image Rejection (F+2xIF) 28dB
Selectivity 20dB
Frequency response ±6dB (100 - 2.3kHz, 5mV)
PHYSICAL SPECIFICATIONS
Dimensions (W x H x D) Net 435 x 133 x 350mm
17 1/8”x 5 1/4” x 13 3/4”
Gross* 435 x 149 x 396mm
17 1/8”x 5 3/4” x 15 5/8”
Net Weight 20.72 lbs (9.4 kg)
Shipping Weight 24.25 lbs (11 kg)
PREAMPLIFIER SECTION
LINE LEVEL INPUTS (MP, CD, DISC, AUX, TAPE)
Input impedance (R and C) 22kΩ + 100pF
Input sensitivity 250mV (ref. rated power)
Maximum input signal 6V
Signal / Noise ratio A-weighted 95dB
Signal / Noise ratio pre-amp out,
A-weighted 107dB
Frequency response <±0.3dB (20Hz - 20kHz,
Tone defeat ON)
<±0.3dB (20Hz - 20kHz,
Tone defeat OFF)
THD + Noise, SMPTE IM < 0.01% at 5V out
LINE LEVEL OUTPUTS
Output impedance
Pre-out 80Ω
Record Out Z+ 1kΩ
Maximum output level
Pre-out 11V
Record Out 11V
TONE CONTROLS
Treble ±5dB at 10kHz
Bass ±8dB at 100Hz
TRIGGER OUT
Output resistance 75Ω
Output current 150mA
Output voltage 12 ±1V
POWER AMPLIFER SECTION
Continuous output power into 8Ω 2x50W (17dBW)
Rated distortion
(THD 20Hz - 20kHz) 0.02%
Clipping power 61W
(maximum continuous power
per channel 4Ω and 8Ω)
IHF Dynamic headroom 8Ω +3.1dB
4Ω +4.7dB
IHF dynamic power 8Ω 102W(20.0dBW)
(maximum short term 4Ω 148W (21.7dBW)
power per channel) 2Ω 205W (23.1dBW)
Damping factor
(ref. 8Ω, 1kHz) >110
Input impedance (R & C) 20kΩ + 1nF
Input sensitivity
(rated output into 8Ω) 730mV
Voltage gain 28.7dB
Frequency response 20Hz - 20kHz ±0.2dB
Signal/noise ratio, A-weighted 102dB
THD + Noise <0.02%
SMPTE IM4 <0.02%
IHF IM5 <0.01%
Headphone output impedance 220Ω
> SPECIFICATIONS
C 725BEE Stereo Receiver
NAD Electronics International reserves the right to change specications or features without notice.
NAD is a registered trademark of NAD Electronics International. All rights reserved. No part of this
publication may be reproduced, stored, or transmitted in any form whatsoever without the written
permission of NAD Electronics International. © 02/09 NAD Electronics International.
www.NADelectronics.com
* Gross dimensions include volume knob / speaker terminals / connectors / feet. Note: Installers
should allow a minimum clearance of 2- 4 inches for wire/cable management.
To Previous Page
Loading...
