Need help?Do you have a question about the NAD C 730 and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz |
|---|---|
| Total Harmonic Distortion | < 0.03% |
| Signal-to-Noise Ratio | >98dB (A-weighted, ref. 1W) |
| Dimensions | 435 x 110 x 390mm (W x H x D) |
| Weight | 8.4 kg |
| Input Impedance | 47k Ohms |
| Input Sensitivity | 200 mV |
| FM Tuner Frequency Range | 87.5MHz - 108MHz |
| Damping Factor | >100 |
| AM Tuner Frequency Range | 530kHz - 1710kHz |
Lists fuse types and part numbers for safety replacement.
Emphasizes leakage current/resistance measurements before returning to customer.
Details specifications for the power amplifier stage.
Details specifications for the pre-amplifier stage.
Lists specifications for the AM tuner.
Lists specifications for the FM tuner.
Details the connections and labels on the rear panel.
Details the controls and indicators on the front panel.
Describes setup for FM signal measurements.
Describes setup for AM signal measurements.
Details alignment steps for the amplifier section.
Lists input signal parameters for FM/RDS tests.
Alignment procedures for AH version AM section.
Alignment procedures for C version AM section.
Schematic diagram for the main board.
To Next Page
