* Gross dimensions include extended buttons and rear panel terminals.
** Non-metric measurements are approximate. NAD Electronics will not assume any liability for errors being made by retailers, custom installers,
cabinet makers, or other end users based on information contained in this document.
Note: Installers should allow a minimum clearance of 55mm for wire/cable management.
Specifi cations
AUDIO SPECIFICATIONS D 3020
Rated Power at 8 ohms 2 x 30 Watts
IHF Dynamic Power 8 ohms 2 x 65 Watts
4 ohms 2 x 105 Watts
2 ohms 2 x 150 Watts
Signal/Noise Ratio (A-weighted) ≥90dB
Channel Separation
1kHz
10kHz
≥75dB
≥65dB
Channel Balance 0 ±0.3dB
Frequency Response (20Hz - 20kHz) 0dB to -0.3dB
Total Harmonic Distortion ≤0.005%
Maximum input level 5V
IMD (SMPTE) 0.02%
IMD (CCIF) 0.003%
GENERAL SPECIFICATIONS
Standby Power ≤0.5 Watts
Supports bit rate/sample rate up to 24/192 (via Digital Audio input)
up to 24/96 (via Computer/Type B USB input)
Unit Dimensions (W x H x D) Gross*
58 x 186 x 219mm
2 5/16 x 7 3/8 x 8 5/8” **
Net Weight 1.38kg (3.05lb)
Shipping Weight 2.1kg (4.6lb)
5
To Next Page
Loading...
