EQ
The M32 has the following Tone Control levels – Treble, Bass and Balance.
Bass and Treble controls only aect the low bass and high treble leaving
the critical midrange frequencies free of coloration. The Balance control
adjusts the relative levels of the left and right speakers.
h : Slide to adjust treble, bass or balance level.
: Slide to turn ON or OFF Tone Controls. At OFF setting, tone
controls (Treble and Bass) are disabled or defeated – Balance option
remains available.
SETUP
The Setup menu contains the menu options for Speaker Setup, Source
Setup, Digital Output and Control Setup.
SPEAKER SETUP
SPEAKER COMPENSATION
The digital impedance compensation lter provides ne tuning of the
top octave to match your speaker impedance. This results in perfectly at
frequency response at 20 kHz. The eect of this lter may not be audible*
but it is measurable and it compensates for the small eect of the digital
reconstruction lter that eliminates the 844 kHz sampling frequency of the
amplier.
* The exception may be some electrostatic speakers that have very low
impedance at high frequency. The lower the HF impedance, the greater
the deviation from at response.
SUB OUTPUT
At “ON” Setting, all subwoofer settings are in eect. At “OFF” setting, all
subwoofer settings are disabled. With Sub Output set to “ON”, the following
subwoofer settings can be setup.
IMPORTANT
Set the “Sub Output” option under “Speaker Setup” settings to “ON” for
the OUTPUT terminals to function as Subwoofer out. On the other hand,
the OUTPUT terminals will function as PRE-OUT if the “Sub Output”
option is set to “OFF”.
OPERATION
USING THE M32
13
To Next Page
Loading...
Need help?
General
Weight and Dimensions
