S-43
03-M Series, WSM
DIESEL ENGINE
• The following special tools are not provided, so make them referring to the figure.
Injection Pump Pressure Tester
Application: Use to check fuel tightness of injection pumps.
W10252400
Valve Guide Replacing Tool
Application: Use to press out and press fit the valve guide.
W1025017
A
Pressure gauge full scale : More than 29.4 MPa (300 kgf/cm
2
, 4267
psi)
B Copper gasket
C Flange (Material : Steel)
D Hex. nut 27 mm (1.06 in.) across the plat
E Retaining nut
FPF 1/2
G 5 mm (0.20 in.)
H 17 mm dia. (0.67 in. dia.)
I 8 mm dia. (0.31 in. dia.)
J 1.0 mm (0.039 in.)
K 17 mm dia. (0.67 in. dia.)
L 6.10 to 6.20 mm dia. (0.2402 to 0.2441 in. dia.)
M 8 mm (0.31 in.)
N 4 mm (0.16 in.)
O 11.97 to 11.99 mm dia. (0.4713 to 0.4720 in. dia.)
PPF 1/2
Q 23 mm (0.91 in.)
R 17 mm (0.67 in.)
S 4 mm (0.16 in.)
T 12.00 to 12.02 mm dia. (0.4724 to 0.4732 in. dia.)
U 100 mm (3.94 in.)
V M12 × P1.5
a Adhesive application
b Fillet welding on the enter circumference
A 20 mm dia. (0.79 in. dia.)
B 12.7 to 12.9 mm dia. (0.500 to 0.508 in. dia.)
C 7.5 to 7.6 mm dia. (0.295 to 0.299 in. dia.)
D 225 mm (8.86 in.)
E 70 mm (2.76 in.)
F 45 mm (1.77 in.)
G 25 mm dia. (0.98 in. dia.)
H 5 mm (0.197 in.)
I 7.7 to 8.0 mm dia. (0.303 to 0.315 in. dia.)
J 20 mm dia. (0.787 in. dia.)
K 13.5 to 13.8 mm dia. (0.531 to 0.543 in. dia.)
L 8.9 to 9.1 mm (0.350 to 0.358 in.)
C1 Chamfer 1.0 mm (0.039 in.)
C2 Chamfer 2.0 mm (0.079 in.)
C0.3 Chamfer 0.3 mm (0.012 in.)
To Next Page
Loading...
