EasyManua.ls Logo

Nanni T6.280 - Maintenance Intervals

Nanni T6.280
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
MAINTENANCE
PÉRIODICITÉ
Daily
1
st
Maintenance
30 days or
25 hours (
1
)
Every
250 hours or
1 year (
1
)
Every
500 hours or
2 years (
1
)
Every
1000 hours or
4 years (
1
)
COMPONENTS
FUEL CIRCUIT
Water in fuel - Pre-lter / Filter Draining
Fuel lter (
2
)
Injectors - Check the compensation codes values with the diagnostic tool (
4
).
Mechanical Injectors T6 Engines
LUBRICATION CIRCUIT
Engine oil level (
2
)
Engine Oil (
2
)
Oil lter (
2
)
COOLING CIRCUIT
Coolant level (
2
)
Coolant liquid (
2
)
Thermostat Inspection (
2
)
Calibrated Heat-Exchanger Cap (
2
)
Heat-exchanger - O-rings
Inter-cooler - O-rings (
4
)
RAW WATER CIRCUIT
Raw Water Filter (
2
)
Raw Water Pump Impeller(
2
)
Anodes Check (
2
)
AIR INTAKE & EXHAUST GAS CIRCUIT
Turbo-charger Inspection (
4
)
Turbo Waste-Gate Free Movement & Lubrication (
4
)
Turbo-charger Heat Insulator (
4
)
Air Intake Filter (
2
)
Exhaust Mixer Inspection (
2
)
ELECTRICITY/ ELECTRONIC
Battery electrolyte level
Electrical Harness Connectors Inspection
Alternator Belt Tension (
2
)
Panel Command : Indicators & Warning Lamps
Read and Records Defect Trouble Codes (
4
)
WHOLE ENGINE
Engine Mounts Inspection
Engine Alignment
Hoses / Clamps tightness / Bolts / Nuts Tightening
Visual Inspection (Coolant, fuel, oil, exhaust & raw water leaks)
Valves Clearance (
5
)
Timing Belt (
5
)
TRANSMISSION
Transmission Oil level (
3
)
Transmission Oil (
3
)
Transmission Oil Filter (
3
)
Transmission & Fuel Coolers
(
1
) Whichever come rst (at the rst occurrence)
(
2
) Operations to be performed in accordance with user and maintenance manual for your engine. For all technical information specic to your engine, refer to the user and maintenance manual.
(
3
) Operation to be perform in accordance with the manufacturer user and maintenance manual
(
4
)
The mechanical injection engines T6.420TDI - T6.300 - T6.280 et Z6.300 are not concerned.
(
5
) The V8 engines T8V320 - T8V350 et T8V370 are not concerned.
CONTROL / ADJUST / CLEAN / SERVICE/ REPLACE IF NECESSARY REPLACE
S08 MAINTENANCE

Table of Contents

Related product manuals