65
POWER ASSISTED STEERING OIL LEVEL
STERN DRIVE VERSION ONLY
The tank mounted on the engine allows to check the oil
level of the power steering.
1. Remove the plug, wipe clean the dipstick.
2. Replace the plug and remove it again.
3. Check that the oil level is between the Mini and
the Maxi mark. If the level is too low, ll to a safe
operating level as indicated by the dipstick. Do not
exceed the maximum level.
4. Use the specic fluid for power-assisted steering
or Dextron III automatic transmission fluid. Replace
the fill cap and dipstick.
S08 MAINTENANCE
STERN DRIVE GEAR LUBE (Z SERIES)
CAUTION !
Damage to the Stern Drive unit may occur due to lack of
lubrication.
If any water is visible at the bottom of the gear lube
monitor, or if the gear lube appears discolored, stop
the engine except in case of emergency, and contact
a NANNI workshop. it may indicate a water leak in the
Stern drive unit.
Check the gear lube with the engine cold, before starting.
1. Check the gear lube monitor to determine the gear
lube level. The appropriate level should be between the
Mini and Maxi level marks.
2. Add gear lube if necessary. Remove the gear lube
monitor cap and add a high performance gear lube for
Stern drive.
To Next Page
Loading...
Need help?
General
