Nanni T6.280 User Manual

68
DRAINING THE COOLANT CIRCUIT
1. Stop the engine and remove the key from the panel.
2. Put a container under the drain plug (B) to collect
coolant. Unscrew the plug and remove the ller cap
on top.
3. Drain off all coolant. Empty the recovery container as
well as the hoses.
4. Insert a hose into the heat exchanger ller port. Rinse
with fresh water until water which flows from the
drain port is clean.
5. Reinstall the drain plug, secure it and ll with new
coolant as explained on next paragraph..
COOLANT - FILLING
Mix the anti-freeze with water in a clean container before
lling the heat exchanger. The coolant must be totally
free from dust. Fill the exchanger slowly not to introduce
air into the coolant system.
Refer to the chapter TECHNICAL DATA (Specications)
to know the coolant capacity of the heat exchanger.
For Keel Cooling system or when using a water boiler,
the coolant capacity must be adapted according to the
pipes length and the tank capacity.
S08 MAINTENANCE
TO FILL THE COOLANT SYSTEM:
1. Check that the drain plug (B) is properly tightened.
2. Add coolant through the heat exchanger ller port
on top (A). Stop lling when coolant is reaching the
bottom of the ller cap lip.
3. Close and secure cap.
4. Start the engine and let it operate few minutes at
idle. Stop the engine, wait few minutes and check
the coolant level in the heat exchanger and in the
expansion tank. Top up if necessary.
CAUTION !
If a boiler is connected to the engine, follow the lling
procedure given by the manufacturer of the boiler. If
the boiler is above the engine in the boat, rst ll the
heat exchanger, the boiler, and top up with coolant the
recovery tank located above the boiler.
Make sure not to overll the heat exchanger when lling
with coolant. If too much coolant has been added, drain
part of the coolant.

Nanni T6.280 Specifications

General

Brand	Nanni
Model	T6.280
Category	Engine
Language	English