76
FUSES
If the engine does not start or if the dashboard does not
work, it is possible that the electrical system is defective
and a fuse has blown on the general installation.
Check the cause before replacing the defective fuse
immediately. Keep an assortment of spare fuses on
hand. Replace one fuse with another of the same value.
CAUTION !
If the replaced fuse blows again, the failure is larger than
a simple incident. If you are still at shore, do not start
the engine, and check rst on your on in taking all usual
precautions. If the fault is not resolved quickly, contact
your nearest Nanni representative for repair.
If you are at open sea, try to locate the fault and to repair
by yourself. Depending of the severity of the fault and
if the event is endangering navigation, establish a radio
contact to get help. Take steps as advised.
S08 MAINTENANCE
MICELLANEOUS
CAMSHAFT TIMING
Timing is ordered through a belt cased inside the grey
cover shown below:
The timing Belt must be replaced in
accordance with the Nanni service
maintenance chart, even with no visual
defect, and must be performed by an
authorized Nanni representative.
Never let any oil to drop onto the timing belt. Should this
happen, have the belt replaced immediately. Do not run
the engine without the cover tted and secured in place.
Cam belt (generic image)
To Next Page
Loading...
Need help?
General
