EasyManuals Logo

Nanni T6.280 User Manual

Nanni T6.280
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
61
S08 MAINTENANCE
REPLACING THE FUEL FILTER
NOTE !
To ease up the air bleeding during fuel lter replacement,
the lter assembly may be lled with some fuel, only if
you are sure not to spill any.
Above picture : fuel lter assembly.
1. Close the fuel butterfly (control) valve. Wipe up the
holding lter bracket with a clean non flint cloth.
2. Remove the protective tank.
3. Put a plastic bag over the lter (A) to prevent spills
on the engine.
4. Remove the fuel lter. Use a lter wrench tool if lter
is seized.
5. Check and clean the sealing surface of the lter
bracket. Apply a thin lm of fuel onto the seal.
6. Screw the new lter by hand until the seal is flush
with the matting surface. Thight up a further half
turn.
AIR FILTER BLEEDING
Bleeding the air in the fuel system might be required :
• After a maintenance operation on the fuel system.
• If the fuel tank has been emptied.
• The engine has not been started for a long time.
TO BLEED THE FUEL SYSTEM FITTED WITH THE
STANDARD MECHANICAL PUMP :
1. Fill up completely the fuel tank. Open the fuel valve.
2. To avoid spills, Dispatch a non flint cloth around the
nose tubing (C) of the fuel lter holder and loose it up
(see picture on left side of this page).
3. Pump the fuel using the push button (B) back and
forth until fuel free of air bubbles flows out of the
venting screw.
4. At this stage, you can tighten the venting screw.
5. Pump a few more times to make sure to prime
completely the system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nanni T6.280 and is the answer not in the manual?

Nanni T6.280 Specifications

General IconGeneral
BrandNanni
ModelT6.280
CategoryEngine
LanguageEnglish

Related product manuals