W415-0931 / A / 11.04.10
12
6.0 MAINTENANCE
Turn off electric appliance or the house circuit breaker to the appliance before performing any cleaning and/or
maintenance. Allow electric appliance to cool completely.
Most halogen lamps are rated to last approximately 1800 hours. Like all lamps, halogen lamps require periodic
replacement.
BULB TYPE:
G9 40W MAX
6.1 REPLACING THE LAMP
A. Remove the glass front.
B. Unscrew the access cover by removing two screws.
C. Remove the lamp and replace with the new one.
D. Re-install the cover.
!
WARNING
PREPARATION FOR MAINTENANCE
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
DO NOT INSTALL REPLACEMENT LAMPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE HALOGEN LAMPS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LAMPS TO AVOID
ACCIDENTAL BURNS.
DO NOT HANDLE THE LAMP WITH BARE FINGERS, OILS FROM YOUR SKIN WILL DAMAGE THE
LAMPS WHEY THEY HEAT UP. USE GLOVES OR A CLEAN DRY CLOTH WHEN HANDLING LAMPS.
To Next Page
Loading...
