EasyManua.ls Logo

Napoleon IR3GN - User Manual

Napoleon IR3GN
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
W415-1355 / 10.01.14
EN
FR
PG
41
$10.00
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE.
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone (705)721-1212 • Fax (705)722-6031 • www.napoleonfi replaces.com • ask@napoleonproducts.com
1.36D
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
SAFETY INFORMATION
!
WARNING
- Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fi re department.
- Installation and service must be performed by a
qualifi ed installer, service agency or the supplier.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certifi ed kit is used.
If the information in these instructions
are not followed exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
WARNING
A barrier designed to reduce the risk of burns from the
hot viewing glass is provided with the appliance and
shall be installed.
CERTIFIED
Decorative Product: Not for use as a heating appliance.
BARRIER
SAFETY BARRIER
CONFORMS TO AMERICAN NATIONAL STANDARDS: ANSI Z21.50, CERTIFIED TO CANADIAN CSA 2.22 FOR VENTED GAS FIREPLACES.
IR3GN
NATURAL GAS
IR3GP
PROPANE

Table of Contents

Other manuals for Napoleon IR3GN

Questions and Answers

  • B
    Breanna AnthonySep 23, 2025
    What to do if my Napoleon IR3GN Indoor Fireplace is over-fired or under-fired?
    • S
      smooreSep 23, 2025
      Check pressure readings: Inlet pressure can be checked by turning screw (A) counter-clockwise 2 or 3 turns and then placing pressure gauge tubing over the test point. Gauge should read as described on the chart below. Check that main burner is operating on 'HI'. Outlet pressure can be checked the same as above using screw (B). Gauge should read as described on the chart below. Check that main burner is operating on 'HI'. AFTER TAKING PRESSURE READINGS, BE SURE TO TURN SCREWS CLOCKWISE FIRMLY TO RESEAL. DO NOT OVER TORQUE.
  • A
    Amber BradshawSep 12, 2025
    What position should the control module switch be in on my Napoleon IR3GN Indoor Fireplace?
    • H
      heatheryoungSep 12, 2025
      Verify the ON/OFF switch is in the 'I' position, which denotes on.
  • J
    Justin MyersSep 9, 2025
    How to check for loose connections on my Napoleon Indoor Fireplace?
    • J
      jacksongeneSep 9, 2025
      To check for loose connections, verify there are no loose connections or electrical shorts in the wiring, and that nothing is grounded out to any metal object.
  • G
    Gary GreenAug 27, 2025
    How to unlock the remote for my Napoleon Indoor Fireplace?
    • R
      Robert WestAug 27, 2025
      To reset a locked-out remote, turn the power source off and then on again. Note that if backup batteries are installed, they must also be removed to reprogram.
  • E
    eugene92Aug 29, 2025
    What to check if my Napoleon IR3GN has no power?
    • J
      John RichardsonAug 29, 2025
      If there's no power to the system, check the breaker to verify it’s in the 'ON' position.
  • R
    Robert ParrishAug 30, 2025
    How to fix poor flame rectification on Napoleon IR3GN?
    • D
      Derek SchmittAug 30, 2025
      To improve flame rectification, ensure the flame is engulfing the sensor rod. This will increase the flame rectification. Verify correct pilot orifice is installed and inlet gas specifications to manual. The sensor rod may also need cleaning.
  • A
    Anthony BaileySep 1, 2025
    Why is the transmitter not working on my Napoleon Indoor Fireplace?
    • C
      christophertapiaSep 1, 2025
      If the transmitter isn’t operational, check the battery power and battery orientation.
  • B
    Brian ChanSep 2, 2025
    How do I clean a dirty sensor rod on my Napoleon Indoor Fireplace?
    • K
      Kenneth MeadowsSep 2, 2025
      If you suspect a damaged pilot or dirty sensor rod, verify that the ceramic insulator around the sensor rod is not cracked, damaged, or loose. Also, verify the connection from the sensor rod to the sensor wire. Clean the sensor rod with a green Scotch-Brite to remove any contamination. Verify continuity with multimeter with ohms set at the lowest range.
  • S
    Samantha WrightNov 25, 2025
    How to reset the ignition box on my Napoleon IR3GN?
    • A
      Anna SheaNov 25, 2025
      To reset the ignition box when locked out, turn off the power supply and remove batteries (if used) from the back up battery pack. To reset the DFC Board when the board goes into a lock out condition and the LED is blinking 3 times using the transmitter ON/OFF button: Step 1: Turn the system off by pressing the ON/OFF button. Step 2: After approximately 2 seconds press the ON/OFF button on the transmitter again. THE DFC Board will reset and the ignition sequence will start again. To reset the DFC Board when the board goes into a lock out condition and the LED is blinking 3 times by cycling flame: Step 1: In the manual flame control mode, use the down arrow button to reduce the flame to off, indicated by the word OFF displayed on the transmitter LCD screen. Step 2: Wait approximately 2 seco...
  • S
    Shirley ThomasSep 12, 2025
    What position should the receiver switch be in on my Napoleon IR3GN Indoor Fireplace?
    • C
      cmcdonaldSep 12, 2025
      Ensure that the 3-position switch on the receiver is in the 'REMOTE' position (middle).

Napoleon IR3GN Specifications

General IconGeneral
BrandNapoleon
ModelIR3GN
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals