Nastec MIDA 207 - Disassembly and Repair; Disposal; Transport and Storage; Transport

WARNING
Failure to comply with the instructions may lead to loss of warranty.
3.5. Disassembly and repair
If it is necessary to disassemble and repair the device, it is recommended that the safety instructions be strictly
observed.
WARNING
The installation, use and maintenance of the product are strictly for qualified personnel who have
undergone appropriate training. Any use by unqualified personnel must be carried out under the
approval, responsibility, and close monitoring of the latter.
WARNING
Failure to follow the instructions may result in damage to the product, the system in which it is
installed and, in the worst cases, damage to property or persons with even fatal consequences.
WARNING
Failure to comply with the instructions may lead to loss of warranty.
TIP
For more information contact the dealer or technical support at service@nastec.eu or by opening a
support ticket on the portal service.nastec.eu
3.6. Disposal
Devices marked with this symbol cannot be disposed of in household waste but must be disposed of at appropriate
waste drop-off centres. It is recommended to contact the Waste Electrical and Electronic Equipment drop-off
centres (WEEE) in the area. If not disposed of properly, the product may have potential harmful effects on the
environment and on human health due to certain substances present within. Illegal or incorrect disposal of the
product is subject to severe administrative and/or criminal penalties.
4. Transport and storage
4.1. Transport
Avoid subjecting the product to severe shocks or extreme weather conditions during transport. The packaging must
remain dry and at a temperature between -20°C (-4°F) and +70°C (+158°F). Do not stack packages without first
checking feasibility with the manufacturer.
TIP
It is advisable to always indicate FRAGILE on the packaging
4.2. Inspection on delivery
Upon receipt of the product, check:
• the integrity of the packaging
• the integrity of the content
• the presence of all components
In case of problems, notify the forwarder immediately.
MIDA
10