Appendix A Device-Specific Information
M Series User Manual A-42 ni.com
SCC Accessories
SCC provides portable, modular signal conditioning to your DAQ system.
To connect your M Series device to an SCC module carrier, such as the
SC-2345, SC-2350, or SCC-68, use an SH68-68-EP shielded cable.
Use Connector 0 of your M Series device to control an SCC module carrier.
Connector 1 cannot be used with SCCs.
Refer to the SCC Advisor, available by going to
ni.com/info and
entering the info code
rdscav, for more information.
BNC Accessories
Using a BNC Accessory with Connector 0
Connector 0 of your device is compatible with several BNC accessories:
• BNC-2110—Provides BNC connectivity to all analog signals, some
digital signals, and spring terminals for other digital signals
• BNC-2111—Provides BNC connectivity to 16 single-ended analog
input signals, two analog output signals, five DIO/PFI signals, and the
external reference voltage for analog output
• BNC-2120—Similar to the BNC-2110, and also has a built-in function
generator, quadrature encoder, temperature reference, and
thermocouple connector
• BNC-2090A—Desktop/rack-mountable device with 22 BNCs for
connecting analog, digital, and timing signals
You can use the SH68-68-EP shielded cable, to connect Connector 0 of
your DAQ device to BNC accessories.
Using a BNC Accessory with Connector 1
Connector 1 of your device is compatible with BNC-2115. BNC-2115
provides BNC connectivity to 24 of the differential (48 single ended)
analog input signals on Connector 1.
You can use an SH68-68-S cable to connect to the BNC-2115.
To Next Page
Loading...
Need help?
General
