Appendix A Device-Specific Information
M Series User Manual A-128 ni.com
You can use one screw terminal accessory with the signals on either
connector of your M Series device. You can use two screw terminal
accessories with one M Series device by using both connectors.
Cables
In most applications, you can use the following cables:
• SH68-68-EP—High-performance cable with individual bundles
separating analog and digital signals. Each differential analog input
channel is routed on an individually shielded twisted pair of wires.
Analog outputs are also individually shielded
• R68-68—Highly-flexible unshielded ribbon cable
Custom Cabling and Connectivity
The CA-1000 is a configurable enclosure that gives user-defined
connectivity and flexibility through customized panelettes. Visit
ni.com
for more information about the CA-1000.
Refer to the Custom Cabling section of Chapter 2, DAQ System Overview,
for more information about custom cabling solutions.
USB-6259 Mass Termination LED Patterns
Refer to the LED Patterns section of Chapter 3, Connector and LED
Information, for information about the USB-6259 Mass Termination LEDs.
USB-6259 Mass Termination Fuse Replacement
Refer to the USB Device Fuse Replacement section of Chapter 3,
Connector and LED Information, for information about the replacing the
fuse on the USB-6259 Mass Termination.
To Next Page
Loading...
Need help?
General
