National Instruments PXIe-8267 - Moving the PXIe-8267 to a Different System

Moving the PXIe-8267 to a Dierent System
Complete the following steps to move your PXIe-8267 to a dierent system or
chassis with a dierent controller.
Note The following steps apply only if the PXIe-8267 you are moving to a
dierent system is in soware RAID mode.
Note To avoid data loss, do not move, swap, or replace the drives.
1.
When the system boots, go into Disk Management. You will see four dynamic
disks with yellow caution icons. Right-click any disk with a caution icon and
select Import Foreign Disks.
2.
Be sure the
Foreign disk group (4 of 4 disks) checkbox is enabled and click
OK.
© National Instruments
13
PXIe-8267 Getting Started