2-6 | ni.com
Chapter 2 Installation and BIOS Setup
Boot Feature
Quiet Boot
Use this feature to select the screen display between the POST messages or the OEM logo at
bootup. Select Disabled to display the POST messages. Select Enabled to display the OEM
logo instead of the normal POST messages. The options are Enabled and Disabled.
AddOn ROM Display Mode
Use this item to set the display mode for the Option ROM. Select Keep Current to display the
current AddOn ROM display setting. Select Force BIOS to use the Option ROM display set
by the system BIOS. The options are Force BIOS and Keep Current.
Bootup NumLock State
Use this feature to set the Power-on state for the <Numlock> key. The options are Off and On.
Wait For F1 If Error
Use this feature to force the system to wait until the < F1> key is pressed if an error occurs.
The options are Disabled and Enabled.
INT19 (Interrupt 19) Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this item is
set to Immediate, the ROM BIOS of the host adapters will capture Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adapters to function as
bootable disks. If this item is set to Postponed, the ROM BIOS of the host adapters will not
capture Interrupt 19 immediately and allow the drives attached to these adapters to function as
bootable devices at bootup. The options are Immediate and Postponed.
Re-try Boot
When EFI Boot is selected, the system BIOS will automatically reboot the system from an
EFI boot device after its initial boot failure. Select Legacy Boot, to allow the BIOS to
automatically reboot the system from a Legacy boot device after its initial boot
failure. The options are Disabled, Legacy Boot, and EFI Boot.
Power Configuration
DeepSx Power Policies
Use this item to configure the Advanced Configuration and Power Interface (ACPI) settings for
the system. Enable S3 to use Standby Mode (Suspend-to-RAM) and maintain power supply to
the system RAM when the system is in the sleep mode. Enable S4 to use Hibernation mode
(Suspend to Disk) so that all data stored in of the main memory can be saved in a non-volatile
memory area such as in a hard drive and then power down the system. Enable S5 to power off
the whole system except the power supply unit (PSU) and keep the power button alive so that
To Next Page
Loading...
Need help?
General
