© National Instruments | 2-7
RMC-8357 User Manual
the user can wake-up the system by using an USB keyboard or mouse. The options are Disabled,
Enabled in S5, Enabled in S4-S5, and Enabled in S3-S4-S5.
Watch Dog Function
Select Enabled to allow the Watch Dog Timer to reboot the system when it is inactive for
more than 5 minutes. The options are Enabled and Disabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select
4_Seconds_Override for the user to power off the system after pressing and holding the power
button for 4 seconds or longer. Select Instant Off to instantly power off the system as soon
as the user presses the power button. The options are 4 Seconds Override and Instant Off.
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Stay-Off for
the system
power to remain off after a power loss. Select Power-On for the system
power to be
turned on after a power loss. Select Last State to allow the system
to resume its last power
state before a power loss. The options are Power-On, Stay-Off and Last State.
Chipset Configuration
Caution Setting the wrong values in the following sections may cause the system
to malfunction.
CPU Configuration
The following CPU information will display:
• Processor Socket
• Processor ID
• Processor Frequency
• Max (Maximum) CPU Speed
• Min (Minimum) CPU Speed
• Processor Max Ratio
• Processor Min Ratio
• Microcode Revision
• L1 Cache RAM
• L2 Cache RAM
• L3 Cache RAM
• CPU1 Version
To Next Page
Loading...
Need help?
General
