To Next Page

To Previous Page

RMC-8357 User Manual

Link L0p Enable

Select Enable for Link L0p support. The options are Enable, Auto, and Disable.

Link L1 Enable

Select Enable for Link L1 support. The options are Enable, Auto, and Disable.

Isoc Mode

Select Enabled for Isochronous support to meet QoS (Quality of Service) requirements.

This feature is especially important for Virtualization Technology. The options are Enable

and Disable.

Memory Configuration

Enforce POR

Select Enable to enforce POR restrictions for DDR4 frequency and voltage programming.

The options are Enabled and Disabled.

Memory Frequency

Use this feature to set the maximum memory frequency for onboard memory modules.

The options are Auto, 1333, 1400, 1600, 1800, 1867, 2000, 2133, 2200, 2400, 2600, 2667,

and Reserved (Do not select Reserved).

ECC Support

Select Enable to enable Error Checking & Correction (ECC) support for onboard memory

modules. The options are Auto, Enable and Disable.

Data Scrambling

Select Enabled to enable data scrambling to enhance system performance and data integrity.

The options are Auto, Disabled and Enabled.

Enable ADR

Select Enabled for ADR (Automatic Diagnostic Repository) support to enhance memory

performance. The options are Enabled and Disabled.

DRAM RAPL (Running Average Power Limit) Baseline

Use this feature to set the run-time power-limit baseline for DRAM modules. The options are

Disable, DRAM RAPL Mode 0, and DRAM RAPL Mode 1.

National Instruments RMC-8357 User Manual

Other manuals for National Instruments RMC-8357