National Instruments SCB-68 - SCB-68 UG Introduction

SCB-68 UG Introduction
This guide describes how to connect and use the SCB-68 with 68-pin or 100-pin data
acquisition (DAQ) devices and other NI products with a 68-pin SCSI or VHDCI I/O
connector. For a complete list of supported devices and available SCB-68 features,
visit
ni.com/r/scb68dev.
Note To use the SCB-68 with devices without analog input functionality,
you must change the default switch setting. Refer to
Using the SCB-68 in
Direct Feedthrough Mode for more information.
Figure 1. SCB-68 Parts Locator Diagram
3
8
9
1 2
5
6
7
10
8
5
4
1.
Quick Reference Label (Optional)
2. Top Cover
3. 68-Pin Connector Screws
4. Lock Washers
5.
Shielding Screws
6. 68-Pin I/O Connector
7.
Base
8.
Strain-Relief Screws
9.
Strain-Relief Hardware
10.
SCB-68 Board Assembly
© National Instruments
3
SCB-68 Getting Started