National Instruments SCXI Series - Page 70

Index
SCXI-1120/D User Manual I-2 www.natinst.com
configuration, 2-1 to 2-13. See also
installation.
analog configuration, 2-8 to 2-13
direct temperature connection, 2-10
gain jumpers, 2-10 to 2-12
grounding, shielding, and
reference-mode selection,
2-8 to 2-9
jumper W41 (table), 2-10
jumper W46, 2-8 to 2-9
SCXI-1120 filter jumpers,
2-12 to 2-13
SCXI-1120/D filter jumpers, 2-13
digital signal connections, 2-4 to 2-8
jumpers W42 and W43, 2-5 to 2-6
jumpers W44, 2-6
summary of jumper settings (table),
2-7 to 2-8
jumpers
fixed jumpers, 2-3
parts locator diagram, 2-2
steps for configuring, 2-4
user-configurable jumpers, 2-3
removing SCXI module cover
(figure), 2-4
revision letter location (note), 2-3
Configuration Register, 4-4
conventions used in manual, ix-x
D
DAQD*/A signal
description (table), 3-9
SCXIbus to SCXI-1120/D to DAQ device
pin equivalencies (table), 3-11
diagnostic resources, online, B-1
DIG GND signal (table), 3-9
digital control circuitry, 4-4
digital interface circuitry block diagram, 4-3
digital I/O specifications
SCXI-1120, A-3
SCXI-1120/D, A-8
digital signal connections, 2-4 to 2-8
jumper W42 and W43, 2-5 to 2-6
Revisions A and B of
SCXI-1120, 2-5
Revisions C and later of
SCXI-1120/D, 2-5 to 2-6
summary of settings (table),
2-7 to 2-8
jumper W44, 2-6
all Revisions of SCXI-1120/D, 2-6
description (table), 2-8
Revision C of SCXI-1120/D, 2-6
Revisions A and B of
SCXI-1120, 2-6
summary of settings (table), 2-8
jumper W45 (table), 2-8
direct temperature connection, 2-10
documentation
conventions used in manual, ix-x
National Instruments documentation, x
DTEMP signal (table), 3-4
E
environment specifications
SCXI-1120, A-3
SCXI-1120/D, A-8
equipment, optional, 1-5
F
filter jumpers
SCXI-1120, 2-12 to 2-13
SCXI-1120/D, 2-13
fixed jumpers, 2-3