NV5/NV3.5 Troubleshooting Manual Wiring/connector lists
Issue 3.2 2014-12-10 Page 4-1
Section 4: Wiring/connector lists
This section contains the wiring information for the hard-wired assemblies of the transmitter, and
applicable connector mating information.
Wiring lists provided
Wiring lists are provided in tabular format. Table 4.1 on page 4-2 lists the tables containing wiring
information. These tables provide non-printed wiring pattern, point-to-point (source and destination)
interconnection information.
Wiring lists not provided
Separate wiring lists are not provided for some assemblies, including:
• Assemblies that have a separate maintenance manual. Refer to the appropriate maintenance
manual for detailed wiring information for these assemblies, if provided.
• Assemblies that have their wiring information shown in tables on their assembly detail
drawing(s). Refer to the Mechanical Drawings section of this manual for detailed wiring infor-
mation for these assemblies.
Connector mating information
Where applicable, a connector mating table is provided after the corresponding wiring list. Table 4.2
on page 4-2 identifies all provided connector information.
Wire colours
Every effort is made to manufacture assemblies using the wire colour shown in the Colour column
of the wiring list tables. Sometimes, a white wire will be substituted for the listed colour. In such
cases, wires must be identified by their assigned numbers.
Printed wiring board patterns
Printed wiring pattern information for printed wiring boards (PWBs) is beyond the scope of this
manual, and therefore not provided.
To Next Page
Loading...
