48
5. Observe the cable routing. Disconnect the Speed Sensor
Cable (D) and Power Inlet Cable (E) from the wiring harness
(F).
6. Tie the length of string to the end of the lower Console
Cable (G) at the top of the Mast mount. Pull the cable and
string down through the hole (H) at the base of the Mast so
that the string extends through the mast.
7. Untie the string from the Console Cable (G). Remove the
zipties that attach the lower Console Cable (G) to the Frame.
8. Using the needlenose pliers, unhook the Tension Spring (J) from
the Main Frame. Pull back and release the Magnet Arm (K) enough to
disengage it from the Motor Pulley Shaft (L).
9. Loosen and remove the two hex head bolts (M) from the Servo Motor
(C).
NOTICE: Hold the Servo Motor so that it does not fall.
10. Remove the Servo Motor (C). Discard the old Servo Motor.
11. Installation is the reverse procedure. Adjust the new Servo Motor to
same position recorded in Step 3.
NOTICE: Do not touch the Potentiometer (N). Do not crimp any
cables.
12. Tie the end of the string at the base of the Mast to the end of the
Console Cable (G) on the new Servo Motor (C). Carefully pull the cable
through the hole (H) to the top of the Mast mount. Untie the string and
discard it.
G
F
E
D
A
C
G
H
K
L
J
M
A
A
C
N
B
To Next Page
Loading...
Need help?
General
