Nautilus R618 User Manual

18
1RWH Your machine may not match the image. For reference only.
1. Disconnect and reconnect the AC Adapter from the wall
RXWOHWWRWXUQWKHSRZHURႇDQGRQ
2. Push QuickStart and verify that the console shows that
the default resistance level is 4.
'LVFRQQHFWDOOSRZHUDQGDOORZWRVLWIRU
minutes.
3. Carefully remove the Left Shroud and Right Shroud.
(Refer to the “Replace the Shrouds” procedure.) Do not
remove the Console and Mast, and keep the Power Inlet
cable (P) in the Shroud connected to the wiring harness on
the motor (D). Slide the Top Shroud up the Mast. Balance
the Top Shroud on the Mast to keep it clear of the pulley
assembly.
Note: If it is necessary to remove the Top Shroud,
reinstall the Console and Mast.
 ,QVHUW´[´FDUGERDUGEHWZHHQWKH%UDNH0DJQHW
(A) and the Flywheel (B), and tape the cardboard to the
Brake Magnet.
Note: Be sure the cardboard covers all of the Brake
Magnet.
5. Turn the power on again.
0DFKLQHLVRQ&XUUHQWLVDFWLYH7KHUHLVULVNRI
HOHFWULFDOVKRFN
6. Use the console to set the resistance to the highest
level. This moves the Brake Magnet Arm (A1) forward. After
the Brake Magnet Arm stops at the highest resistance level,
WXUQSRZHURႇ
'LVFRQQHFWDOOSRZHUDQGDOORZWRVLWIRU
minutes.
NOTICE: It is necessary to remove the shrouds for this procedure. Refer to the “Replace the Shrouds” procedure.
P
B
A
A1
D
Left side
Right side
D
A
B
A1

Nautilus R618 Specifications

General

Resistance Levels	25
Bluetooth Connectivity	Yes
Workout Programs	29
Resistance Type	Magnetic
Display	LCD
Heart Rate Monitoring	Contact
Warranty	10 year frame, 1 year labor