67
NOTICE: It is necessary to remove the Shrouds for this procedure. Refer to the “Replace the Shrouds” procedure.
1RWH Your machine may not match the image. For reference only.
1. Carefully remove the Left Shroud. Refer to the “Replace
the Shrouds” procedure in this manual.
2. Carefully disconnect the Power Inlet cable (A) in the
Shroud from the wiring harness (B) on the motor.
Disconnect all power to the machine before you service it.
A
B
B
A
Recumbent bike
Upright bike
To Next Page
