To Next Page

To Previous Page

10. Using a #2 Phillips screwdriver, loosen and remove the

screw that secures the front Seat Rail End Cap. Bend the

edges of the rear Seat Rail End Cap to disengage the inside

tabs from the Main Assembly, and remove. Set the hardware

and Caps safely aside for reassembly.

11. Using a #2 Phillips screwdriver, remove the screws

(indicated) that secure the Left Rear Shroud. Remove the

ERWWRPVFUHZV¿UVWDQGWKHQWKHWRSVFUHZV6ORZO\UHPRYH

the Left Shroud. Set the hardware and Left Shroud safely

aside for reassembly.

12. Using a #2 Phillips screwdriver, remove the screws that

secure the Right Rear Shroud. Slowly remove the Right

Shroud. Set the hardware and Right Shroud safely aside for

reassembly.

13. 8VLQJDPPKH[ZUHQFKORRVHQDQGUHPRYHWKH

bolts that attach the back of the Seat Rail and the 4 bolts at

the front of the Seat Rail. Set the hardware safely aside.

Disconnect the HR and Resistance cables in the Seat Rail

Assembly and the Frame. Carefully remove the Seat Rail

Assembly from the Frame and set it safely aside.

NOTICE: Do not crimp any cables.This step may require

two people.

Nautilus R628 Service Manual

Other manuals for Nautilus R628