Nautilus T618 Service Manual

45
13.Usinga6mmhexwrench,removethe
hardware from the Left Upright. Be prepared
to support the Upright when the hardware is
removed.
14.Usinga6mmhexwrench,removethe
hardware from the Right Upright. Slightly
remove the Right Upright from the Base
AssemblyexposingtheInput/Output(I./O)
Cables. Disconnect the I/O Cables and remove
the Right Upright.
Note: Do not crimp cables.
X2
X2
15.Makesurethereissufcientspacetotiltthewalkingdeckontotheleft
side and then onto the Walking Belt. The Walking Belt should rest on the
ground.
Keep a minimum clearance behind the machine of 79” (2 m)
and 24” (0.6 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
Note: THE FOLLOWING STEP MAY REQUIRE A SECOND PERSON.
16. With the assistance of at least a second person, tilt the Base Assembly
onto the left side, and then onto the Walking Belt.
Be sure the area is clear around the Base Assembly before
ipping it. Do not grasp the Walking Belt since it can abruptly
move.

Nautilus T618 Specifications

General

Foldable	Yes
Bluetooth Connectivity	Yes
Cooling Fan	Yes
Running Surface	20" x 60"
Incline Range	0% to 15%
Speed Range	0 to 12 MPH
Display	LCD
Programs	26
Heart Rate Monitoring	Yes
Weight Capacity	350 lbs
Audio	Yes
Dimensions	57.6" H