45
Nautilus® Commercial Series Bike Owner’s Manual
Press [ENTER] to select your option.
Adjust lower LCD screen contrast
Use the [Level: UP] and [Level: DOWN] keys to increase or decrease the contrast level of the upper LCD.
Press [ENTER] to select your option.
Reset Defaults
This code will reset all exercise parameters to the factory defaults. Press [ENTER], to accept the default
values.
3. To exit “CUSTOMIZE”, press the [CLEAR] key.
Machine Status Codes
To view maintenance information such as the run time in hours, number of workouts and distance, as well a
machine type and software revision:
1. Press [Level: UP], [4], [ENTER]. The console will display “MACHINE STATUS”
2. Press [Level: UP] or [Level: DOWN] to scan through the choices to view. Press [CLEAR] to exit the machine
status codes.
The machine status options are as follows:
Machine run time in hours
Display the machine run time in hours. The console will display “RUN HOURS #####”.
Number of workouts
Display the number of times a workout key has been pressed. The console will display “WORKOUTS ####”.
Distance traveled
Display the total distance traveled in miles (or kms if console is set to Metric units) . The console will display
“DISTANCE #####”.
Software revision
Display the console software revision number. The console will display “CONS 41375-###”.
Machine type
Display the machine type the console is currently configured to. The console will display “U/R916” or other
machine type.
CONSOLE CODES
To Next Page
Loading...
