51
Maintenance
STORAGE
If the dumper is to be stored for a long period of time the following procedures should be
applied.
•
Thoroughly wash down the exterior of the machine and remove any build-up of material.
•
Grease all greasing points.
•
Start the engine to warm it up. Drain the engine oil and refill with clean fresh oil to the
correct specification. Also drain the coolant from the system and replace with fresh
coolant of the correct mix & specification.
•
Check hydraulic oil level and top up as required.
•
Fill the fuel tank to prevent condensation forming inside the tank and contaminating the
fuel.
•
Store the machine on flat level ground which is not liable to flooding, standing water or
airborne contamination.
•
Smear any exposed metal parts & hydraulic ram rods with grease.
•
Remove the battery and store in a safe, well ventilated area. DO NOT store the battery on
a concrete floor. It is best to place a rubber mat between the battery and the floor.
•
Securely chock the wheels or preferably the dumper may be lifted clear of the ground and
placed on suitable axle stands to prevent damage to the tyres.
•
The engine should be run under no load for at least 5 minutes every 2-3
months.
•
If you forget to run the engine for a period of longer than 5-6 months. Oil
will need to be applied to the valve guide and valve stem seal. Make sure
the valve runs smoothly before starting the engine.
To Next Page
Loading...
