Installation 22
User Settings
Use the chart below to document your system and terminal settings:
Parameters Examples: Your Settings:
Number of sessions
Host/Printer (Session 1)*
Host/Printer (Session 1)*
Emulations (Session 1)
Emulations (Session 2)
2
EIA/Para
Aux/None
ADDS-VP
VT-300-8
Host 1:
Baud
Data Bits
Stop Bits
Parity
Parity Check
Flow Control (In)**
Flow Control (Out)***
Modem Control
9600
8
1
None
Off
Xon-Xoff
Xon-Xoff
On
Dual Host mode only, press
CTRL-Enter (kpd):
Host 2:
Baud
Data Bits
Stop Bits
Parity
Parity Check
Flow Control (In)**
Flow Control (Out)***
Modem Control
19200
7
2
Odd
On
DTR (or DSR)
DTR (or DSR)
Off
Notes: * In most cases, these paramet
ers should not be the same.
** Incoming flow control on the host should correspond to “EIA (or Aux) Rcv.”
*** Outgoing flow control on the host should correspond to “EIA (or Aux) Xmt.”
To Next Page
Loading...
