EN
11 Cleaning and maintenance
Cleaning
Occasionally clean the product with a damp cloth.
Maintenance
WARNING! Electrocution hazard
• The device fuse may only be changed by qualified personnel.
• Contact an authorized service agent.
The device fuse must be replaced aer it has been triggered by excess current.
Replace the fuse as shown.
fig. on page2
12 Troubleshooting
Problem Possible cause Suggested remedy
Insulation faults, breaks or loose con-
nections at the live cables.
Check live cables for insulation
faults, breaks or loose connec-
tions.
If you cannot find an error, con-
tact an authorized service agent.
The charger does not work. The LEDs
do not light up.
Short circuit has been generated.
The device fuse must be re-
placed after it has been trig-
gered by excess current.
The two LEDs flash red. The device fuse is defective.
The device fuse must be re-
placed after it has been trig-
gered by excess current.
13 Disposal
Recycling packaging material: Place the packaging material in the appropriate recycling waste bins wher-
ever possible.
Recycling products with non-replaceable batteries, rechargeable batteries or light sources:
• If the product contains any non-replaceable batteries, rechargeable batteries or light sources, you
don't have to remove them before disposal.
• If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for
details about how to do this in accordance with the applicable disposal regulations.
• The product can be disposed free of charge.
14
To Next Page
Loading...
Need help?
General
