INFO LED
Start Cleaning
Press Start Button 1x for house
cleaning
Press Start Button 2x for spot
cleaning
Solid Blue
Solid White
Pause/Resume
Cleaning
Press Start Button during
cleaning to pause robot.
Press Start Button again to
resume cleaning.
LED pulses
during pause
Cancel
Cleaning
Press & hold Start Button for 5
seconds
Robot & LEDs
turn off & robot
plays a tone.
NOTE: If the INFO LED light is blinking red or solid red, your robot needs robot maintenance or your robot has a
navigation Please check the troubleshooting section of this guide.
BATTERY LED
ROBOT
IS:
LED
COLOR
WHAT IT MEANS
Cleaning
Solid
Green
Battery level is normal
Solid
Amber
Battery level is low.
Battery must be charged
before a new cleaning can
be started
Charging
Pulsing
Green
Battery is charging and
robot can start cleaning
Pulsing
Amber
Robot is fast-charging the
battery and must
complete before cleaning
can start
NOTE: If Blinking Red, please check the troubleshooting section of this guide.
How Neato Works
HOUSE CLEANING
In normal operation, Neato comes off of its base, explores its surroundings and starts cleaning. It starts cleaning in
sections approximately 15’x15’ depending on layout and furniture in the room. It will continue to clean section by
section until the entire area is cleaned.
Your Neato robot will also try to clean one room fully before moving on to the next, assuming it can detect your
doorways. If it cleans a partial room, your Neato robot will come back to finish the room before finishing the complete
job.
AUTO CHARGE AND RESUME
If the area the Neato robot is attempting to clean is very large, the robot will return to its base mid-cleaning to
recharge. Once recharged, it will return to finish where it left off. A complete cleaning cycle includes 3 cleanings and 2
recharges so that Neato can clean very large areas on one level.
To Next Page
Loading...
