Choose a wall outlet that has a 3’ (1 m) clearance on both sides and in front of the charge base. This helps your
robot find the charge base. Plug in the power cord and push the charge base against the wall.
TIP: Locate the charge base on a hard floor surface.
TIP: Make sure the power outlet is not controlled by a switch.
INITIAL ROBOT CHARGING
Place the rounded side of your Neato robot against the metal charging contacts on the charge base until the contacts
are pushed all of the way in. For best results, charge the robot fully before your first cleaning cycle to experience a
full high performance cleaning.
To Next Page
Loading...
