NEC CP/M-86 - Page 179

Appendix A
Escape Sequences
This appendix summarizes the escape sequences for the APC under CP IM-86. The
following symbols are used in the escape sequence descriptions:
Pn = Decimal parameter expressed in ASCII digits
Ps = Selective parameter that can take on only the specific values listed
Multiple parameters are separated by ASCII semicolon characters
(3BH).
1. ANSI-Compatible Escape Sequences
Cursor Movement Commands:
Cursor up
Cursor down
Cursor forward (right)
Cursor backward (left)
Direct cursor addressing
where
P 1 = line number
Pc = column number
ESC[PnA
ESC[PnB
ESC[PnC
ESC[PnD
ESC[PI;PcH or ESC[PI;Pcf
A-I