Advanced
BIOS
Functions
6-8
AUXILIARY
CHARACTER
SET
ESC(l
This function is used to access the auxiliary character codes
(20H -
FDH)
created by
the
CHR
utility. The one character immediately following the escape sequence
is
treated as the auxiliary character code. In Direct Console
1/0
(BDOS function
6)
the available auxiliary character codes have a range
of
OOH
to
FFH.
SETA
MODE
NOTE
The character immediately following ESC
is
the open parentheses character, (,
not
the
square bracket.
ESC[>Psh
This sets the mode specified by the parameter. Only the values listed below may be
used. All other parameters values are ignored.
Parameter
I
2
5
7
RESET A
MODE
ESC[>Psl
Mode
Disable system status display
Disable key click
Disable cursor display
Disable keyboard input
This escape sequence resets the mode specified by the parameter. Only the values
listed below may be used. All
other
parameter
values are ignored. The final
character
is
the lowercase letter
1,
not
the number one.
Parameter
I
2
5
7
Mode
Enable system status display
Enable key click
Enable cursor display
Enable keyboard input
To Next Page
Loading...
