NEC DT300 Series - Login and Logout Procedures

21
3. BASIC OPERATION
Login (DT700 Series Only)
When login mode is activated, following procedure is
required.
 Enter login code and press Set Soft key.
(The station number is used as the Login code.)
 Enter the password and press OK Soft key.
 If the login code is accepted, display changes to
normal idle status.
4:26 PM TUE 13 APR 2008
MIC DND >>>
Logout (DT700 Series Only)
 Press the pre-assigned Logout Feature Key on the
terminal.
Note: This location is an example.
Note: Logout button is assigned by data setting at
the ECP (Enterprise Communication Platform).
4:26 PM TUE 13 APR 2008
MIC DND >>>
 “LOGOUT?” is displayed on the LCD of the terminal.
4:26 PM TUE 13 APR 2008
L-OUT >>>
 Press the Logout Feature Key on the terminal
again.