EasyManua.ls Logo

NEC DT300 Series - Last Number Redial; CID Call Back; Call Redirect

NEC DT300 Series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
Last Number Redial
To Recall The Last Number Dialed
Press Redial key. Receive special dial tone.
REDIAL[#]/SPEED[ ] -1
2001
Last number dialed
Press #. The number dialed will be redialed and
displayed.
REDIAL[#]/SPEED[ ] -1
2001
Last number dialed
NOTE: Each time the Redial key is pressed the
numbers dialed for the last five calls are displayed
sequentially.
CID Call Back
To Search, Call Back, or Erase A Calling Number
Using soft-keys
Lift the handset or press Speaker key.
Press Message key.
Press Search soft key to search for desired number.
Press CB soft key to call back desired number.
Press Erase soft key to erase desired number.
To Search, Call Back, or Erase A Calling Number
Without Using Soft-keys:
Lift the handset or press Speaker key.
Press Message key.
Dial 1 to search for desired number.
Dial 2 to call back desired number.
Dial 3 to erase desired number.
Call Redirect
To Redirect With Calling Party Information
While in the CID mode press CRD key.
Call is transferred to a pre-assigned destination
station.
To Redirect Without Calling Party Information:
Press CRD key.
Press incoming line key or line key on hold.
Call is transferred to a pre-assigned destination
station.
NOTE: See CID Display; Access to feature is based
on data assignment.

Table of Contents

Related product manuals